Integrated Back-up Battery System IBBS

TCW TECHNOLOGIES

Integrated Back-up Battery System IBBS

Integrated Back-up Battery System IBBS

Catalog No:

Manufacturer: TCW TECHNOLOGIES

Questions about the product protection? See the Warranty FAQs.

Integrated Back-up Battery System IBBS

The Integrated Back-up Battery System, IBBS, is an electronic system that combines a Lithium-Iron-Phosphate (Li-Fe-PO4) battery pack, a charger and switching logic in one convenient package.  The IBBS provides an engineered solution to enable an endurance bus for critical loads found in aircraft. It simplifies the wiring and installation of a source of back-up power by integrating all of the key elements into a single enclosure.  The IBBS system provides back-up power to critical electronic loads such as EFIS, GPS, Autopilots and engine monitor systems.  

Integral to the IBBS is a lithium-iron-phosphate battery pack and a matched charging system to ensure the battery is properly charged and maintained.  The system also includes switching circuitry to provide a stable source of output power during normal and emergency operations.  The IBBS system also provides signals to other equipment such as EFIS systems to communicate the operating state of the back-up bus as well as the state of the battery.

The IBBS system connects to the standard aircraft power bus and provides an output to critical equipment that requires back-up power.  Additionally, the IBBS system provides surge and sag protection for connected equipment, allowing operation of critical equipment during engine starting.

The IBBS system is suitable for use with equipment such as Garmin GNS and GTN series navigators, G3X series of avionics, Grand Rapids Technologies EFIS systems, Advanced Flight Systems EFIS, Dynon EFIS, and MGL EFIS, TruTrak Autopilots and EFIS, Trio Autopilots.  

SPECIFICATIONS:     IBBS-12v-3ah

Input Voltage: 12-15 volts DC

Transition Voltage: 10.5-11.5 volts 

Input Current: 2.2 amps max continuous on main input for charging

Pass-thru Current: 5 amps continuous, 10 amps peak

Output Voltage: 10-14 volts DC during back-up operation

Output Current: 5 amps continuous/10 amps peak for radio transmissions and transient loads

Battery: Internal sealed Li-Fe-PO4

Charger: Integral high performance fast charger

Surge Protection: 34 volt active clamp, 1500w 10/1000uS waveform

Wiring: 15 pin male D-sub on product.

Enclosure: Aluminum  7.7” x 2.3” x 1.6”
                                                                                                
Weight: 18 oz.

Temperature range: Operating  -10 C° to 60 C°/Charging      0 C° to 40 C°

Connector: Standard density 15 pin male D-sub on product                    

General Wiring Diagram:

                                                

Shopping Cart

Your cart is currently empty.

Continue Browsing