12 Volt, 8 Amp Aviation Battery Charger/Maintainer/Desulfator

Guaranteed to never overcharge/undercharge. (33°F to 130°F)

Tested and endorsed by leading Battery makers.

100% Full - Time U.S. Patented Pulse-type Desulfation keeps battery free of sulfate or dissolves sulfate completely in older batteries.

Detects and rejects batteries with bad cells. Terminate charge to prevent out-gassing.

Maximize battery life and capacity, recovers weak batteries.

Diagnoses battery’s condition / state-of-charge.

Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.

Maintain up to 2 batteries at a time. (requires BatteryMINDer® Y-Connector Accessory 210-AY)

Auto-Restart after power failure.

Bad cell detection with auto-shutdown.

Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.

Very high efficiency. California CEC Approved. Certified to California Energy Commission Standards.

Automatically detects input AC power.

ECO-mode with hi-efficiency / low power consumption. This allows the unit to always remain connected to AC while consuming very low level of electricity.

Ambient temperature compensation. Built-in temperature sensor automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)

2 LED indicators show state-of-charge and important status mode / battery condition.

Rugged, vibration-resistant construction.

Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.